Clarke JETSTAR 1700 Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Máquina de suelo Clarke JETSTAR 1700. Clarke JETSTAR 1700 20 páginas. Ultra speed burnisher
También para Clarke JETSTAR 1700: Instrucciones de uso y mantenimiento (8 páginas)
Imprimir página
ABOUT THE MACHINE
How To Assemble
This machine is shipped with the handle assembly
separate from the base. Assemble as follows:
1. Loosen but do not remove the two square head knobs
on the rear of the machine.
2. Insert the handle tube between the frame and handle
clamp until it bottoms.
3. Tighten the two square head knobs to secure the
handle tube.
4. Connect cord set to the motor pigtail.
Install a pad and the machine is ready to operate.
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install the Pads
WARNING: Always remove the electrical
plug from the electrical outlet
before installing or changing the
pad.
The pad driver assembly is on the bottom underside of
the machine. The pad holder holds the pad in position.
The machine has a screw-on pad holder. To install the
pad, follow this procedure:
1. With the handle locked in the operating position, tilt
burnisher back on the handle until the underside of the
burnisher is fully exposed. (See figure 2).
2. Remove the retainer from the pad holder by unscrewing
(turn counterclockwise).
3. Remove the center scored circle from a pad.
4. Place pad on pad driver.
5. Be sure pad is properly centered on the driver.
6. Reinstall the retainer on the pad holder until pad is
tightly secured (turn clockwise).
NEVER OPERATE BURNISHER WITHOUT A PAD.
Page - 6 -
CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700
Figure 2