Clarke MBS600D Manual de instrucciones de montaje - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Sierra Clarke MBS600D. Clarke MBS600D 9 páginas. 600 mm compound mitre saw

USING THE MITRE SAW

CUTTING SIMPLE MITRES OR BEVELS

Simple mitres or bevels are cuts made in one plane only. For simple mitres, the

carriage is moved to the desired angle to the base by pulling the horizontal

quadrant release lever to allow the carriage to swivel, with the saw blade

remaining perpendicular to the table.

Setting the carriage to the angles shown in Fig 6, will produce the mitres

illustrated. The angle is shown by the pointer.

COMPOUND MITRES

For compound mitres the saw frame

is tilted over at an angle to the table.

This is done by releasing the large

socket bolt in each end of the mitre

carriage sufficiently to free the

vertical quadrant and to allow the

saw frame to be tilted to the desired

angle. The socket bolt is then

tightened when the saw frame is set

at the desired angle.

Compound mitres are therefore cut

using a combination of these

settings.

CUTTING TECHNIQUE

When cutting, DO NOT force the saw blade, as this will lead to blade

distortion and inaccurate mitres/bevels. Only a very gentle pressure is

required. Let the saw do the work.

Ensure the socket screws at both ends of the carriage are tight before use.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

FIG 6

SOCKET

BOLT

VERTICAL

QUADRANT

FIG 7