Clarke WOODWORKER CBS250 Manual de instrucciones de funcionamiento y mantenimiento - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de funcionamiento y mantenimiento para Sierra Clarke WOODWORKER CBS250. Clarke WOODWORKER CBS250 13 páginas. 45 mm (10”) bandsaw & stand
También para Clarke WOODWORKER CBS250: Instrucciones de uso y mantenimiento (20 páginas)
Imprimir página
wear proper apparel. loose clothing or jewellery may
ALWAYS
14.
get caught in moving parts. wear protective hair covering to
contain long hair.
15.
ALWAYS
use recommended accessories. the use of improper
accessories could be hazardous.
ALWAYS
16.
remove plug from electrical outlet when adjusting,
changing parts, or
working
on the machine.
NEVER
operate machine while under the influence of drugs, alcohol or any medication.
17.
NEVER
18.
leave machine running unattended. turn power off.
Do not leave the machine until it comes to a complete stop.
NEVER
force the machine. it will do a better and safer job at
19.
the rate for which it was designed.
NEVER
use power tools in damp or wet locations or expose
20.
them to rain. Keep your work area well illuminated. do not
use in explosive atmosphere (around paint, flammable liquids
etc).Avoid dangerous environment.
ADDITIONAL PRECAUTIONS FOR BANDSAWS
ALWAYS
check safety guards are in place and functioning correctly before switching
1.
the machine ON.
ALWAYS
2.
use a push stick, especially on small workpieces.
ALWAYS
3.
use the appropriate saw blade for the material being cut.
DO NOT
4.
use the machine if the electric cable, plug or motor is in poor condition.
DO NOT allow the ventilation slots in the motor to become blocked.
5.
6. DO NOT
touch the blade immediately after use, when changing blade always allow
time for it to cool.
DO NOT
use bent or cracked blades.
7.
8.
Replacement blades are available from your CLARKE dealer.
9.
Replace table insert if slot has become enlarged.
10. When cutting wood, ensure all nails have been removed
beforehand. Nails will damage the saw blade.
11. When cutting boards in upright position use a suitable push
block to prevent kickbacks
12. When cutting round stock, use a suitable jig or fixture to keep
the work from turning.
13. Ensure the blade is fully tightened and correctly adjusted
before use.
14. Keep the mains cable well away from the machine and
ensure an adequate electrical supply is close at hand so
that the operation is not restricted by the length of the cable.
15. Switch the machine OFF immediately the task is completed.
Additionally, please keep these instructions in a safe place for future reference.
-4-
Parts List
Item
Part No
Description
-17-
Qty