Clarke woodworker CMS10 6501305 Instrucciones de uso y mantenimiento - Página 12
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Sierra Clarke woodworker CMS10 6501305. Clarke woodworker CMS10 6501305 20 páginas. 10” compound mitre saw
Imprimir página
C. Straight Bevel Cutting
As with Mitre Cutting, this is a cross cutting operation, except that the blade is not
perpendicular to the table, (see fig. 5).
Ensure the table is set to 0
locked in place using the table knob.
The bevel adjuster is factory set so
that when the head is tilted to its
fullest extent the blade will cut a
perfect 45° bevel.
If however you require any other
angle, you should proceed as
follows:
Cut a mitre of the required angle,
on a spare piece of wood, and use
this as a template for your bevel cut.
Fig.6
D. Compound Mitre and Bevel Cutting.
Having determined the angles you
require, firstly set the bevel angle, using
the procedure described above, and
then the mitre angle.
NOTE: Compound mitre and bevel
cuts, at a full 45°, can only be made
when the head is turned to the left.
The procedure for cutting is the same
as that for cross cutting.
O
, and is
Slacken off the bevel locking lever, and
swing the head to the side. Lower the
arm, and bring your template up to the
saw blade. When satisfied that the edge
of template and blade are parallel, lock
the head in position with locking lever.
Your angle is now set.
The procedure for cutting is the same as
that for cross cutting....press trigger, wait
for full speed to develop, push safety
lever to one side, then lower the blade
to the workpiece.
12
Fig.5