Clarke 3110855 Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Herramientas Clarke 3110855. Clarke 3110855 17 páginas. 3” cut-off tool

BEFORE USE

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF COM-

PRESSORS AND COMPRESSED AIR SUPPLIES.

Note: Ensure the compressor is turned off.

1. Remove the plastic blanking plug from the connection port of the tool as

shown.

2. Pour 2-3 drops of CLARKE airline oil into the air inlet. This should be done

regardless of whether or not a lubricated air supply is to be used.

3. Connect a suitable hose to the tool as shown.

4. Connect the other end of the hose to the compressor. (A whip hose with a

quick fit coupling is available from your CLARKE dealer).

5. Turn on the air supply and check for air leaks. Rectify any found before

proceeding. The tool is now ready for use.

CAUTION: ENSURE YOU READ, UNDERSTAND AND APPLY SAFETY IN-

STRUCTIONS BEFORE USE.

1. Push safety lever (mounted on the throttle lever) forward and depress

throttle lever.

•

Allow tool to run up to full

speed for a couple of seconds

before offering disc to work

piece.

2. Apply a steady, even pressure.

Do not force the tool. Too much

pressure can cause disc to break

and may even cause injury.

NOTE: DO NOT allow tool to free run

for an extended period of

time as this will shorten its life.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]