Clarke 3120178 Instrucciones de uso y mantenimiento - Página 9
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Herramientas Clarke 3120178. Clarke 3120178 17 páginas. Needle scaler/chisel kit
Imprimir página
OPERATION
WARNING: ALWAYS WEAR PPE TO PROTECT YOURSELF FROM FLYING
PARTICLES WHEN USING THIS PRODUCT.
USING THE TOOL
1. Hold the tool firmly, then bring the
tool towards the work at an angle
of approximately 60-70 degrees.
2. Pull the trigger with the chisel in
light contact with the work.
3. Move slowly across the work
surface. To remove scale, rust or
other contaminants, only a light
force should be required.
4. Release the trigger to stop
operation, whilst maintaining contact with the work. Note that the tool may
run briefly after the trigger is released.
5. Needle or chisel force can be
adjusted by turning the regulator
knob located at the base of the
hand grip.
6. To increase speed, turn the
regulator clockwise or anti-
clockwise to reduce.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the compressed air supply hose until the air supply has
been shut down or isolated at the shut off valve and the compressed air
expelled by running the tool until it stops.
2. Refer to the compressor instruction manual for the procedure to shut down
and release the compressed air.
3. Once the pressure has been released, disconnect the air supply hose from
the needle scaler.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9