Clarke 6500101 Manual de instrucciones de uso y mantenimiento - Página 9
Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Herramientas Clarke 6500101. Clarke 6500101 12 páginas. Pipe notcher
Imprimir página
5. Open the drill chuck jaws and
lower the chuck onto the notcher
spindle, aligning the chuck jaws
with the flat sides of the notcher
spindle. Tighten the chuck jaws to
secure.
NOTE: Failure to align the spindle
flats properly with the chuck
jaws may result in the spindle
coming loose and
damaging the notcher and
drill chuck.
6. Adjust the base of the notcher until it is flat to the drill press table, then
tighten the hex bolts from step 2.
7. Secure the base to the table with
bolts, strap clamps or "C" clamps.
8. Remove the spindle lock pin, then
rotate the drill chuck by hand to
test how easily the assembly turns.
NOTE: If assembly turns with minimal
effort, proceed to step 10.
NOTE: If assembly does not turn with
minimal effort, proceed to
step 9.
9. Loosen the 2 hex bolts securing the notcher base to the frame, rotate
spindle then tighten hex bolts, then repeat step 8. repeat until assembly
turns with minimal effort.
10. Loosen bolts/clamps, securing the notcher to the drill press table, rotate
spindle, then tighten the bolts/clamps. Spindle should turn freely.
11. When the notcher is correctly
installed on the drill press, remove
the spindle lock pin, apply cutting
fluid, turn drill press on and
perform notching operation.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9