Clarke CAT151 Instrucciones de uso y mantenimiento - Página 10
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Herramientas Clarke CAT151. Clarke CAT151 17 páginas. Air/hydraulic riveter
Imprimir página
MAINTENANCE
WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE
PROCEDURES.
DAILY
1. Before use, drain water from the air-line and compressor.
2. Maintain the tool with care. Keep it oiled for optimum performance.
3. Lubricate the air tool daily with a high quality air tool oil either via an oiler in
the air supply system or by placing a few drops into the riveter air inlet
immediately before use. This should be carried out regardless of whether or
not an in-line mini oiler is used. If an in-line mini oiler is not used, this
procedure should be repeated after every two hours of constant use.
CLEANING
1. Keep the tool clean.
2. Deposits in the tool may also reduce efficiency. This can be corrected by
cleaning the air inlet and flushing out the tool with gum solvent oil, or failing
this, the tool should be disassembled, thoroughly cleaned, dried and
reassembled.
3. If the tool becomes inefficient and the air supply is of good quality, it may
be necessary to replace worn or damaged parts. You may prefer to take
the tool to your Clarke dealer if internal maintenance is required.
CHANGING JAWS
1. Disconnect the tool from the air
line.
2. Remove the outer cylinder (fig 9)
using the spanner provided.
3. Use both spanners to unscrew the
front jaw case (fig 10) from the rear
jaw case.
4. Remove the jaws and clean with
solvent and brush. If the teeth are
blunted, replace with new jaws.
Reverse the above procedure to reassemble.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10