Clarke CAT29B Instrucciones de uso y mantenimiento - Página 7
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Herramientas Clarke CAT29B. Clarke CAT29B 13 páginas. Air hammer kit
También para Clarke CAT29B: Instrucciones de uso y mantenimiento (7 páginas)
Imprimir página
1. If required, connect an in-line mini oiler to the tool.
• A mini oiler helps to prolong the life of the air tool. Read the
instructions supplied with the mini-oiler before use.
2. Connect a suitable hose to the tool and the other end of the hose to the
compressed air supply.
3. Turn on the air supply and check for air leaks. Rectify any found before
proceeding.
• PTFE tape may be helpful for sealing threaded connections.
• Your air tool is now ready for use.
FITTING THE CHISEL
1. First remove the retaining spring
from the nose by unscrewing it.
• Use the inboard lug to gain
purchase.
2. Insert the chisel into the air
hammer as shown.
3. Replace the retaining spring as
shown.
• Use the lugs to tighten.
USING THE AIR HAMMER
1. Hold the tool firmly, then bring it
towards the work at an angle of
approximately 60-70 degrees.
2. Pull the trigger with the chisel in
light contact with the work.
3. Move slowly across the work
surface. To remove scale, rust or
other contaminants, only a light
force should be required.
4. Release the trigger to stop operation, whilst maintaining contact with the
work.
5. Chisel force may be adjusted by turning the regulator knob, located at the
base of the handle grip. Turn anti-clockwise (unscrew) to increase force,
clockwise (screw in) to reduce.
NOTE: that the tool may impact briefly after the trigger is released.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7