Clarke CAT99 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Herramientas Clarke CAT99. Clarke CAT99 17 páginas. 3” cut-off tool

2. If no line lubricator is used, ensure that oil is applied to the tool on a daily

basis through the air inlet connection.

3. For lubricating the air motor, an air line lubricator should be used,

containing Clarke Air Line Oil, adjusted to 2 drops per minute. If this is not

possible, run a few drops of oil through the tool. It may be entered into

the tool air inlet, (ensuring the strainer is clear), or into the hose at the

nearest connection to the air supply. Then operate the tool.

Clarke Airline Oil is available from your CLARKE dealer, Part No 3050825.

CLEANING

1. Keep the body of the tool clean and free from debris.

2. Grit or gum deposits in the tool may also reduce efficiency. This condition

can be corrected by cleaning the air strainer and flushing out the tool

with gum solvent oil, or failing this, the tool should be disassembled,

thoroughly cleaned, dried and reassembled.

3. After extensive use, remove the

inlet screen filter and flush out the

mechanism with gum solvent oil

or an equal mixture of SAE No10

oil and paraffin. Allow to dry

before use.

4. Clean the air inlet filter screen

inside the hose adaptor.

5. If the tool runs erratically or

becomes inefficient, and the air

supply is of good quality, it may

be necessary to dismantle the air motor and replace worn or damaged

parts. You may prefer to take the tool to your CLARKE dealer if internal

maintenance is required.

Your Clarke cut-off tool has been designed to give long and trouble free

service. If, however, having followed the instructions in this booklet carefully,

you encounter problems, take the unit to your local Clarke dealer.

SERVICE AND REPAIRS

1. Keep the tool clean at all times, and ensure that the bolts securing the

case remain tight.

• All bearings etc, in this machine are lubricated with sufficient high grade

lubricant for the machines lifetime under normal operating conditions,

therefore no further lubrication is required.

• Be aware that outside factors may effect operation and efficiency, These

may include reduced compressor output, excessive drain on the airline,

moisture in suspension or restrictions in the line, or the use of connectors of

improper size or poor condition which will reduce air supply.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

Gauze Filter

(located here)