Directus Intraphex UCI-11C Manual - Página 4
Navegue en línea o descargue pdf Manual para Sistema de vídeo para coches Directus Intraphex UCI-11C. Directus Intraphex UCI-11C 9 páginas. Rear view camera & navigation solution for dodge, chrysler & fiat uconnect touch
Imprimir página5. Gain access to the rear of the screen & disconnect the 3 cables that are attached.
6. Set the unit aside for ease of installation of the UCI.
7. The free end of the 22 pin T-harness that is plugged into the radio head, is routed behind the dash to the screen
location.
8. The 18 pin connector is inserted into the port labeled "Radio T-harness".
9. Locate the WHITE, ROUND connector that was removed from the screen. Insert this cable into the WHITE port
labeled "LVDS IN".
10. Take the provided LVDS cable and insert the BLACK end into the BLACK port (LVDS OUT). The other end will be
connected to the screen later.
11. If installing a rear view camera, insert the 8 pin MOLEX plug into the port labeled "Video IN". Of the connections
available, there's;
a. Twisted Pair – Used for factory installed camera only on the 4.3" screens. This input is not used on the
8.4" screens. On the 8.4" screens, the factory camera input is on the back of the radio head.
b. Video 1, 2 & 3- Used for an aftermarket camera input using composite video (yellow RCA connection).
*Power connections for the rear view camera can be made at the cigarette lighter.
12. If installing navigation into the system, proceed to the navigation installation section. Otherwise continue to
step 13.
13. After all the connections are made, securely mount the UCI module in the dash.
14. Connect the WHITE end of the provided LVDS cable into the screen. Make all other connections and reassemble
the radio/screen.
15. Make the necessary changes in the SETUP menu & test.
16. Using the plastic pry tool, gently pry around the dash panel to release the locking tabs. Take extra care when
releasing these tabs, they may fall from the dash panel and into the dash.
If Installing Directus Navigation
Once you complete step 12 of the UCI installation, continue from this point.
1. Plug in the supplied 24 pin Navigation harness into the port labeled NAVIGATION/AV.
2. Route this cable down to the driver's side under dash or any location that is secure. Be sure to securely fasten it
to existing wiring and brackets. Route away from any sharp or moving parts.
3. Using Velcro, secure the module. For added stability, a large zip tie should be used to secure the module in
place.
4. Plug the routed cable from the UCI into the
Directus navigation unit.
a. Black Din - RGB
b. Grey Din – DATA
c. 4-pin MOLEX – DC IN
5. Included in the kit is an external speaker, it is used for turn by turn navigation or any audio output from the
navigation unit. The speaker can be mounted on one of the metal rails running vertically under the steering
column. It is recommended that the speaker faces the opening under the steering column for best volume.
6. Plug the speaker into the 3.5mm jack labeled SPK on the navigation.
NOT USED
4 |
P a g e