Clarke CDTJ12 Manual de instrucciones de uso y mantenimiento - Página 7
Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Herramientas Clarke CDTJ12. Clarke CDTJ12 12 páginas. Dovetail jig
Imprimir página
PLACING THE TIMBER INTO THE JIG
1. Align the timber so that the side of the workpiece is mounted in the front
vertical clamp.
• It should extend above the front edge of the jig by the thickness of
the piece to be mounted under the top clamp (front or back of the
drawer).
2. The piece of timber in the top
clamp is then butted up to this, so
that both pieces are flush under
the template.
3. The two pieces sit in the jig as
shown on the right.
• Make sure that both pieces are
butted up against the
horizontal / vertical stops.
4. Use the locking clamp handles to
secure the wood to the jig.
• You may need to adjust the top
and front clamp bars to suit the
thickness of the timber using
the clamp adjusting screws at
either end of each clamp bar
so that the wood is held firmly in
place
• When narrow pieces of wood
are being used, place another piece of wood (exactly the same
thickness) underneath the clamp bar at the opposite end to ensure
an even grip on the wood and to avoid distorting the bars.
SETTING THE TEMPLATE POSITION
1. Unlock the two template securing
screws and position the template
so that the tips of the fingers sit
3mm back from the edge of the
vertically mounted timber.
2. Lock the template into position
using the two template securing
screws.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7