Claro CFCLSU2LWHABS Manual de instalación - Página 11

Navegue en línea o descargue pdf Manual de instalación para Ventilador Claro CFCLSU2LWHABS. Claro CFCLSU2LWHABS 15 páginas.

REVERSE FUNCTION

The "Summer/Winter" reverse function is included in the remote control to make the fan rotate in

an anti-clockwise direction during summer.

In winter, this can be reversed, so that the blades now move in a clockwise direction.

Press and hold "F/R" button for 3 seconds to switch between "Summer" and "Winter modes

CARE & CLEANING:

• Periodic cleaning (approximately 6 months) of your ceiling fan is the only maintenance required.

• Use a soft brush or lint free cloth to avoid scratching the finish. Please turn off electricity when you

do so.

• Do not use water when cleaning your ceiling fan. It could damage the motor or the wooden blades

and create the possibility of an electrical shock.

• The motor has a permanently lubricated ball bearing and as such, is maintenance free.

NOISE:

The manufacturer warranty covers actual faults that may develop, but NOT minor complaints, e.g.

motor operation noise - ALL ELECTRIC MOTORS ARE AUDIBLE TO SOME EXTENT; this is more

obvious when the fan is operating at low speeds.

WOBBLE:

• Ceiling fans are designed to move during operation because they are not generally rigidly mounted

• Movement of a couple of centimetres is acceptable for safe operation.

• Balancing kits included should be used to adjust the balancing when first installed.

NORMAL WEAR AND TEAR:

Threaded components working slighting loose or blade carriers even slightly bent due to

vigorous cleaning or bumping can cause extra wobble and noise. THIS IS NOT COVERED UNDER

WARRANTY, but a little care and maintenance can reduce or prevent this problem.

REMOTE CONTROL SETTINGS AND OPERATION FOR DC FANS

NOTE:

The Hand Held Remote Control System is equipped with a learning frequency function which has

code combinations to prevent potential interference from other remote units. The frequency

on your Receiver and Transmitter units have been pre-set at the factory. If the remotes need

programming please following these instructions and use a small size tool to change the code

switch setting for each remote.

All fans are pre-paired and there is no paring process needed to start the fan.

If you want to reset the fan to factory setting. Please follow steps below.

1. Connect power to the fan.

2. Within 10 seconds after turning on the power, short press "ON/OFF" 3 times, followed by the

4th press and hold the button for 3 seconds. Then, the fan will beep once and it means it's paired

successfully.

3. Now test the remote by pressing on speeds or light button.

4. It can take up to 10 seconds for the fan to start moving, after pressing a speed button. The fan

may move a few times slightly backwards and forwards and then will start rotating slowly whilst

building up to the correct speed. This is normal behaviour for DC fans.

Considerations:

1) If the receiver is not receiving a signal from the remote control: