3Com AirProtect Sentry 5850 Manual de inicio rápido - Página 5
Navegue en línea o descargue pdf Manual de inicio rápido para Pasarela 3Com AirProtect Sentry 5850. 3Com AirProtect Sentry 5850 15 páginas. Secure converged networks enterprise edition
También para 3Com AirProtect Sentry 5850: Ficha de datos (4 páginas), Manual del producto (15 páginas)
Imprimir página
2. Preparing for Installation
It is advisable to connect and check the Ethernet cable and LEDs before installing the Sentry in a
hard-to-reach location. Additionally, observe the following items before mounting or connecting
the Sentry:
Feature
Switch Port
Cabling
Power Requirement
MAC Address
3. Attaching the Antennas
Carefully unpack the standard detachable antennas that came with your Sentry. Thread each
antenna onto an antenna connector on the Sentry and hand-tighten them. After network startup,
you may need to adjust the antennas to fine-tune coverage in your area.
For best results, adjust the antennas so they are perpendicular to the floor and ceiling.
CAUTION: Do not handle the antenna tips, especially after they are connected to the
Sentry. This could lead to electrostatic discharge (ESD), which could damage the
equipment.
4. Mounting the AirProtect Sentry
The Sentry can be mounted on the following types of surfaces:
•
Wall, ceiling, or electrical box (NEMA enclosure)
•
Tabletop
Wall, Ceiling, or Electrical Box Mounting
Use the bracket that comes with your Sentry to install it on a wall, ceiling, or electrical box:
1
Route Ethernet cable through the opening in the cradle.
2
Screw the mounting bracket to a wall, ceiling, or electrical box (NEMA enclosure):
•
If mounting to a solid surface wall or ceiling, use the two sheet metal screws.
•
If mounting to drywall, use the two sheet metal screws and two wall anchors.
•
If mounting to an electrical box (NEMA enclosure), use the two threaded screws.
Description
To connect your wireless network to your wired network, you need a
hub or switch connected to the Sentry.
Make sure that standard Ethernet cable with straight-through
signaling is installed at the site before you install the Sentry.
Make sure that the cable is highly flexible and that there is no extra
covering on the RJ-45 connector that could prevent the cable from
being routed through the mounting bracket.
Power is supplied using an 802.3af Power Over Ethernet (PoE)
compliant device such as a switch, or a PoE injector (not included).
Record the access point MAC address in a safe place before the Sentry
is installed in a hard-to-reach location.
The MAC address is printed on the back of the Sentry.
5