Clarus Technologies PCS-35 Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Equipos de limpieza Clarus Technologies PCS-35. Clarus Technologies PCS-35 13 páginas. Agitating cleaning stations

Imprimir página

Light doesn't work:

A.
1. Check power cord, is it plugged into electrical box plug labeled "light bar"?
2. Replace light bulb, 150-watt halogen.
3. Confirm parts washer is plugged into wall outlet.

Fusible Link doesn't line-up with tab on lid:

B.
1. Adjust bolt on fusible link.
2. Switch fusible link to other side of mount on light bar.
3. Loosen and realign light bar and retighten in correct position.
4. Never bend Fusible Link, this will weaken it!
Air Gun has low pressure or doesn't work:
C.
1. Check air source.
2. Check adjustment of regulator.
3. Check air hose for kinks or damage.
4. Confirm air pump is plugged in to the electrical box plug.

Soak Tank Pump doesn't work:

D.
1. Check for defective power cord; plug in pump with extension cord.
2. Inspect pump base screen and impeller for damage or obstruction.
E.

Wand/Brush leaking or drips:

1. Tighten fittings.
2. Remove fittings and remove Teflon tape, then re-tape and re-assemble.
3. Tighten hose clamps.
4. Check for damage and wear, replace as necessary.
F.

Canister Lids difficult to remove and install:

1. Lube lid o-ring and threads with petroleum jelly (note: always apply petroleum
jelly to o-ring with every filter change).
G.

Sight Glass dirty or clogged:

1. Blow clean with air gun or fluid nozzle (opening is inside tank just above pan
opposite sight glass).
2. Replace with new clear hose (Tygon 3/8" ID).
H.

Main Pump not running:

1. Check power cord, is it plugged in to electric box on lower shelf?
2. Plug pump into extension cord.
12