Clarus Technologies WCS-25 Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Equipos de limpieza Clarus Technologies WCS-25. Clarus Technologies WCS-25 16 páginas. Cleaning stations
También para Clarus Technologies WCS-25: Manual del usuario (14 páginas)
Imprimir página
1. This manual describes the procedures required to operate the Clarus PARTS
WASHING/WEAPONS CLEANING SERIES. Every effort has been made by
Clarus Technologies, LLC to assure the accuracy and reliability of the information
contained in this document. Clarus Technologies, LLC, however, makes no
representation, warranty, or guarantee in connection with this manual and hereby
expressly disclaims any liability or responsibility for loss or damage resulting from
its use or for the violation of any federal, state, provincial or municipal regulation
with which this publication may conflict.
The electrical components of the Clarus Parts/Weapons Cleaning Series have been
2.
designed and assembled with UL-approved equipment where required.
WARNING
! The operational techniques used with this equipment are more
important than the design of the equipment for the safety of the worker.
Therefore, each technician involved in the operation of the Clarus
Parts/Weapons Cleaning Series must have the proper hazardous materials
training.
DANGER!
This system can only be used with solvent that has a minimum
flashpoint of 140 Fahrenheit. Use of solvents with flashpoints lower than 140
Fahrenheit are likely to cause a fire, injuries or death. If you are not sure of a
solvents flashpoint refer to the appropriate material safety data sheet
("MSDS") sheet.
3. Clarus is not undertaking to meet the duties of employers to warn and properly train
and equip their employees, and others exposed, concerning health and safety risks
and precautions, nor undertaking their obligations under local, state, provincial or
federal laws.
4. Information concerning safety and health risks and proper precautions with respect to
particular materials and conditions should be obtained from the employer, the
manufacturer or supplier of that material, or MSDS.
FOREWORD
3