CLAS OC 9100 Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Herramientas CLAS OC 9100. CLAS OC 9100 16 páginas. Rear parking sensor punh master tool kit

Imprimir página

REAR PARKING SENSOR PUNCH MASTER TOOL KIT

OC 9100

FORD (23 PCS)

INSTRUCTIONS

• The sensors' position is usually indicated by the manufacturing marks found on the inside of the bumper.

(Fig. 1) There may also be a template suitable for the car or bumper among the components of the adjustment

tool set.

• Drill a hole for each mark using the Ø18 mm drill bit. Place the drill bit exactly in the center of the mark and drill

from the inside to the outside. (Fig. 2)

• Choose the punching machine that matches the mark on the bumper. Insert the punching machine into the

Ø18 mm hole from inside the bumper. Orient the punching machine according to the mark on the bumper.

(Fig. 3)

• Now place the matrix on the bumper as follows: position the corresponding matrix on the punch's shank so

that the guide pin (grub screw on the matrix) fits exactly inside the guide groove on the punch's shank. The

matrix should now adhere to the outside of the bumper.

Tip: in order to protect the bumper, you can first apply some adhesive tape on the painted surface. (Fig. 4+5)