Lenovo A859 Manual de servicio - Página 30

Navegue en línea o descargue pdf Manual de servicio para Teléfono móvil Lenovo A859. Lenovo A859 36 páginas.
También para Lenovo A859: Información importante sobre el producto Manual (23 páginas), Manual de inicio rápido (6 páginas), Manual de inicio rápido (13 páginas), Manual de inicio rápido (33 páginas)

Repair Manual of Lenovo S920 Mobile Phone

Excessive Phase Error

Check the power supply part of PA （U2102） and transceiver

（U2101）

Replace the elements in

solder joint

4.3.4 Power output problems



Fault: Normally power-on and receive, but when outputting two frequency bands or single

frequency band power, there is no input power or the input power is very low.



Cause: There are many reasons for no output power or very low power, which may be the

results of faults of Transceiver output part, PA input and output circuit, antenna connector

and antenna switch control signal or power supply circuit. Specific circumstances are:



RF connector（CON2101）

Checking: Whether RF connector CON2101 and the test probe of RF test cable are well

connected or the patch is oppositely pasted or the antenna connector is damaged.

Shooting: Replace antenna connector and ensure right direction of patch.



RF power amplifier (PA)

A. Whether the control signal PA_ENABLE（Pin17）of PA is high level (about 2.8V); if it

is low level, there is no output of PA;

B. Check the Pin3 Pin4 of PA power supply part to see whether the power supply voltage

is in the normal range (typically 3.6V ~ 4.2V);

C. Whether the RF input parts of PA are in cold solder joint;

D. Whether the RF output R2115,C2131 of PA is in cold solder joint;

E. Part circuit of V_ramp control signal of PA: if it is in old solder joint or in interruption of

circuit, PA also has no output power.



Transceiver（U2101）

A. Whether the power supply voltage of Transceiver（U2101） is within normal range;

check the power supply voltage between power supply filtration capacitor and U2101

connection and then check whether the surrounding circuit is in cold solder joint.

B. Whether there is cold solder joint or short circuit in Transceiver （U2101）.

cold

带格式的: 英语(美国)