Nikon E800 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Microscopio Nikon E800. Nikon E800 22 páginas.
También para Nikon E800: Manual de instrucciones (9 páginas), Manual de instrucciones (42 páginas)

Imprimir página

CAUTION

1. Check the light source

The power supplies V-PS 100DU and V-PS100E provide the power for the halogen lamp that serves as

the microscope light source. Although these power supplies can power a-halogen lamp of up to 12 V/

100 W, the specified lamp and lamphouse must be used. The equipment could be damaged if a non-

specified combination of components is used.

Specified lamphouse : Nikon halogen lamphouse Model C-LP HALOGEN 12V100W

Specified lamp

: Halogen lamp, 12 V-100 W LONGLIFE

OSRAM HLX 64623 or PHILIPS 7724

2. Turn off the power when connecting or disconnecting cables or when replacing the lamp

In order to prevent electric shock and damage to the equipment, always turn the power switch on the

power supply off (flip it to the " " side) and unplug the power cord before connecting or disconnecting

cables or replacing the lamp.

3. Cautions when replacing the lamp

In order to prevent bums, allow the lamp to cool (for at least thirty minutes after turning off the power)

before replacing the lamp. Furthermore, in order to prevent electric shock and damage to the equipment,

always turn the power switch on the power supply off (flip it to the

~ " side) and unplug the power cord

before replacing the lamp.

After replacing the lamp, make sure that the lamphouse cover is securely closed.

Never use the lamphouse while its cover is open.

4. Do not wet

If the microscope or the power supply becomes wet, a short circuit may result and the equipment could

be damaged or could become extremely hot. If you accidentally spill a liquid on the equipment,

immediately turn the power sw itch on the power supply off (flip it to the " " side) and unplug the power

cord. Then use a dry' cloth to wipe away the moisture. If any liquid gets inside of the equipment, do not

attempt to use it; instead, contact your nearest Nikon representative.

5. Weak electromagnetic waves

This microscope emits weak electromagnetic waves. The accuracy of any precision electronic equipment

may be adversely affected if positioned near this microscope. If this microscope affects TV or radio

reception, move the radio or TV away from the microscope.

6. Cautions concerning installation

Be careful not to pinch your hands or fingers when installing the microscope.

This microscope is a precision optical instrument, and using or storing it under unsuitable conditions

may damage it or may have an adverse affect on its precision. See "Installation Location" on P.27, and

use this microscope in a suitable environment.

7. Notes on transport

Because this microscope is a precision optical device, handle it carefully and do not subject it to strong

physical shocks. (The precision of the objective in particular may be adversely affected by even weak

physical shocks.)

When moving the microscope, first detach the lamphouse. Then have at least two people carry the

microscope, at least one on each side, using the carrying handles.

Be sure to screw the carrying handles in as far as they will go and make sure that they are secure. If the

carrying handles are not attached securely, they could come out or break while the microscope is being

carried, creating a hazardous situation. Screw the carrying hadles into the upper holes on the rear of the

microscope. If you use the lower holes, your hands will be caught between the handles and the table

when you place the microscope down. (P.27)

In addition, do not grasp the coarse focus knob, the fine focus knob, the eyepiece tube, the stage, etc.,

when carrying the microscope; there is a chance that the part could come off, and the equipment could be

damaged.