Dirt Devil DDC05-P01 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Aspiradora Dirt Devil DDC05-P01. Dirt Devil DDC05-P01 16 páginas. Cylinder vacuum bagless cleaner

Imprimir página

5.2 CLEANING THE

DIRT CONTAINER AND

PRE-MOTOR FILTER

n It is best to check the pre-motor filter each

time you empty the dirt container,

> Chapter 5.1, 'Emptying the dirt

container'.

n Clean the pre-motor filter at the latest when

the blockage light (Fig. 8/A1) lights up.

1. Switch off the machine, remove the dirt

container and empty it, > Chapter 5.1,

'Emptying the dirt container'.

2. Release the dirt container lid by firmly

turning anti-clockwise (Fig. 9/A). Remove it

from the dirt container.

DD_Real Power M28_OUTPUT-RK.indd 11

CAUTION

The dirt container and the filter elements are washable,

but may not be cleaned in dishwashers or washing-

machines. Also, do not use detergents or brushes with

hard bristles to clean them.

3. Pull the pre-motor filter up and out of the

dirt container (Fig. 9/B).

4. Remove the separator and shroud from

the dirt container in an upward motion

(Fig. 9/ C).

5. Remove any residual dirt still clinging to the

dirt container, separator and shroud using a

dry cloth or a soft brush, e.g. the supplied

furniture brush.

IMPORTANT: Refrain from cleaning the separator and

shroud with water. Otherwise, adhering dirt particles may

clog the separator and shroud.

6. Hold the pre-motor filter low over a dirt bin.

Separate the filter elements from one another.

Remove larger agglomerations of dirt by

hand. Tap filter over a dirt bin to remove any

dirt and debris.

7. Rinse the pre-motor filter under water

(Max 40°C).

IMPORTANT: Let the filters dry for approx. 24 hours

at room temperature after cleaning. Only put them

back into the appliance when they are completely dry.

9. If one of the filter elements is damaged,

replace it with a new one, > Chapter 5.4,

'Spare parts and accessories'.

10. Put the separator and shroud back into the

dirt container (Fig. 10/B). Take care that the

two wide tabs and the narrow tab engage

in the wide grooves and the small groove,

respectively.

11. Reassemble the pre-motor filter and put it

back onto the separator and shroud

(Fig. 11/A).

12. Put the dirt container lid back on (Fig.

11/B). Take care that the two wide tabs

and the narrow tab engage in the wide

grooves and the small groove, respectively.

13. Lock the lid by turning it firmly clockwise

(Fig. 11/C) until it audibly clicks into place.

7 11

26/03/2015 10:48