Dirty Hand Tools 101571 Manual de instrucciones - Página 15

Navegue en línea o descargue pdf Manual de instrucciones para Cultivador Dirty Hand Tools 101571. Dirty Hand Tools 101571 20 páginas. 15” front tine tiller

Imprimir página

Operating Instructions

NEVER FILL THE FUEL TANK ON A HOT ENGINE

Start-Up

e controls required to start and run the tiller are located on

the engine and are marked "Choke" and "

description of engine operation and precautions is available in the

engine operation manual.

STOP

LOW

ENGINE

THROTTLE

Cold Starts

1. Move choke lever to full choke position.

2. Move throttle lever to "start".

3. Pull starting rope out slowly one time and allow to return normally.

4. Pull starting rope out rapidly, and allow rope to return normally.

5. When engine starts, gradually move choke lever to "no choke"

position and increase throttle speed.

Restarting A Warm Engine

Restarting an engine that is already warm from previous running does

not normally require use of the choke.

1. Move throttle lever to "start" position.

2. Pull starting rope out rapidly until engine starts. Allow rope to

return normally. Repeat until engine starts.

3. Adjust throttle speed to "high" for best tiller action.

Idle Speed

Use the "low" position on the throttle lever to reduce stress on the

engine when tilling is not being performed. Lowering the engine

speed to "idle" will help extend the life of the motor, as well as

conserve fuel and reduce the noise level of the equipment.

Operating Speed

For normal tilling, set the throttle lever to "fast".

Shutting Down

To stop the engine at any time, move throttle control to the STOP

position. To stop tines at any time, release the drive control lever.

WARNING

rottle". A detailed

FULL

START

THROTTLE

ENGINE

START