Dirty Hand Tools 104950 Manual de instrucciones - Página 13

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Dirty Hand Tools 104950. Dirty Hand Tools 104950 20 páginas. Vibratory plate compactor

Imprimir página

1. Exciter Lubrication

RECOIL

STARTER

FUEL VALVE

CHOKE

(Model 104001)

Figure 6

Figure 7

Starting the Engine

ENGINE

NEVER FILL THE FUEL TANK ON A HOT ENGINE

ON/OFF

SWITCH

Start-Up

The controls required to start and run the plate compactor are

located on the engine and the handlebars. A detailed description of

engine operation and precautions is available in the engine operation

manual.

Starting a Cold Engine

1. Turn the engine ON/OFF switch to ON (see Figure 6).

2. Move choke lever to the closed (full choke) position.

3. Move fuel valve to open position (Model 104001).

4. Move throttle control lever to low (see Figure 7).

5. Pull recoil handle slowly one time and allow to return normally.

6. Pull recoil handle out rapidly, and allow rope to return normally.

7. When engine starts, gradually move choke lever to "no choke"

THROTTLE

position and increase throttle speed towards full throttle.

Restarting A Warm Engine

Restarting an engine that is already warm from previous running does

not normally require use of the choke. Adjust throttle speed to "high"

for best plate compactor action.

THROTTLE

CONTROL

Idle Speed

LEVER

Use the "low" position on the throttle lever to reduce stress on the

engine when compacting is not being performed. Lowering the

engine speed to "idle" will help extend the life of the engine as well as

conserve fuel and reduce the noise level of the equipment.

Operating Speed

For normal compacting, set the throttle lever to "fast".

Shutting Down

To stop the engine move the engine ON/OFF switch to the OFF

position.

WARNING

START

FULL

ENGINE

THROTTLE

STOP

LOW

STOP

THROTTLE

ENGINE