ABBA STB11 Manual de instalación - Página 3
Navegue en línea o descargue pdf Manual de instalación para Iluminación paisajística ABBA STB11. ABBA STB11 4 páginas.
Imprimir páginafixture(s) must be installed in accordance with all local codes and ordinances.
Do not instal within 10 feet of a pool, spa or fountain
To ensure optimal performance and safety, it is
important to use our fixtures ONLY with a low
voltage landscape transformer. This transformer
reduces the voltage from 120V to 12V, making it
safe and suitable for outdoor use.
When installing the fixture(s), please follow
these instructions carefully:
1.Before
installation,
the power is turned off for your safety.
2.To access the interior of the fixture, simply
loosen and remove the two front screws, which
will allow you to open the fixture. Hold the
outlet against the wall at the desired height and
orientation. Ensure it is level and aligned
according to your preferences.
3. Using a pencil or marker, carefully mark the
hole location on the wall of the outlet box.
4. Select an appropriately sized for the hole,
which should match the diameter of the outlet
box you are using.
5. Position the drill on the marked spot and
gently drill hole into the wall at the marked
location.
6. To prepare the hole required for securing the
fixture for the screws, use a pencil or marker to
meticulously mark the hole's location. Then,
utilize a drill bit that corresponds to the size of
the screws. Take care to ensure a clean and
precise hole, exercising caution throughout the
process.
7. Place the outlet box against the wall, aligning
the screw holes you created. Take the screws
and insert them through the holes in the outlet
box one at a time.
CAUTION:
INSTALLATION INSTRUCTION
please
ensure
that
www.ABBALightingUSA.com
7.For concrete installation, To begin, construct
conduit raceways inside the concrete formwork by
using one-inch dowels and PVC pipe before pouring
the concrete. After the concrete has cured, remove
the dowels and proceed to finish the outer surface
of each riser if you are installing it in stairs.
8.Using a screwdriver, tighten the screws gradually
and evenly, ensuring a secure attachment of the
metal plate to the wall. Be cautious not to
overtighten and damage the wall surface.
9.Confirm that the outlet box is firmly and evenly
attached to the wall, without any wobbling or
misalignment. Use a level to verify that the fixturel
is vertically aligned, as desired.
We recommend using WN12 waterproof wire nuts
(sold separately) for optimal connectivity.
10.Strip
the
insulation:
approximately 3/4 inch (1.9 cm) of insulation from
the ends of the two wires you wish to connect.
Ensure that the bare metal ends are clean and free
from any frayed strands.
11. Align the wires: Hold the stripped ends of the
two wires together, aligning them neatly and
ensuring that no stray strands are crossing over.
12. Insert the aligned ends of the wires into the
wire nut, ensuring that they go all the way in. The
bare ends should be completely covered by the
wire nut. Twist the wire nut: Firmly twist the wire
nut clockwise onto the wires, ensuring a secure
connection. Continue twisting until the wire nut is
tight and snug. Test the connection: Gently tug on
each wire to ensure they are securely held by the
wire nut. For added safety, it is recommended to
apply electrical tape around the wire nuts and
wires as an extra layer of protection.
Carefully
strip