Disaster Area Designs Qconnect Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Equipos de grabación Disaster Area Designs Qconnect. Disaster Area Designs Qconnect 16 páginas. Multi output midi controller
Imprimir páginaC
onfiguring the
We've set some stuff up here at the factory that might make this process a little bit easier!
If all of your MIDI pedals are made by Chase Bliss Audio, you can skip right to the Chase
Bliss Setup Guide on
If any or all of your MIDI pedals aren't made by Chase Bliss, then please read on!
After you've hooked up all of your devices, you'll need to tell qCONNECT what you have plugged
in and where it is plugged in. To make things easier we'll cover the Setup Menu options you
should select.
Power on your qCONNECT by plugging in a 9V power supply and then hold down its left
footswitch.
When you see the display scroll "SETUP" you can let go of the footswitch.
From here you can use the instructions in the Setup Menu section to navigate the menu.
Set DEV to match the number of devices you have connected. If you have 3 devices, set DEV
= DEVC.
Navigate to the device configuration items (DevA - DevJ) and set each one to match the device
you want to use in that location.
Remember - you don't have to connect the channel 1 device (DevA) to Port A! You can use your
devices in any order that makes sense to you, just tell qCONNECT what lives where.
Repeat this process for each connected device. To use our example from earlier, if you had
three devices connected you should make sure that DevA, DevB, and DevC all match what you
plugged in.
Once you have told qCONNECT what order you want your devices to operate in, you need to
tell it which device is on which port.
Navigate to CFG.A (or the first port you're using) in the Setup menu and hold left to edit its
value. It should be set to RING by default, which will work with Chase Bliss devices. If you're
using something else, change it to the correct setting.
Chase Bliss: RING
Empress: TIP
Bondi: TIP
If you've connected devices to Ports X or Y, the options are labeled MID.R for ring and MID.T
for tip. Otherwise they're the same!
Once you have all of your ports set up, hold down the right footswitch to save and exit. The
display should flash "SAVE" to indicate that the save was successful.
If you wish to control one or more devices using the 5-pin MIDI output on the left side of the
qCONNECT you don't need to set up that port. The 5-pin port always sends out the same way,
and doesn't need to be configured.
4
midi o
page
6.
Alexander: TIP
Meris: TIP
utputs