Blacoh SENTRY CIP Manual de instalación y funcionamiento - Página 3
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Equipamiento industrial Blacoh SENTRY CIP. Blacoh SENTRY CIP 12 páginas. Sanitary flow through dampener
También para Blacoh SENTRY CIP: Manual de instalación y funcionamiento (12 páginas)
Imprimir páginaDampeners should only be installed, operated and repaired by experienced and trained professional mechanics.
Read and observe all instructions and safety warnings in this Manual before installing, operating or repairing
dampeners.
The following symbols indicate cautions, warnings and notes that must be observed for safe and satisfactory
installation, operation and maintenance of dampener.
WARNINGS
Danger of serious injury or death could occur if these warnings are ignored.
CAUTIONS
Equipment damage, injury or death could occur if these cautions are not observed.
NOTES
Special instructions for safe and satisfactory installation, operation and maintenance.
C A U T I O N !
Observe all safety symbols in installation and
operation instructions.
The internal dampener pressure will equal the
maximum fluid pressure of the system in which it
is installed.
DO NOT exceed maximum allowable working
pressure (MAWP) specified on dampener serial
tag or marked on dampener.
missing,
DO
NOT
consulting distributor or factory for maximum
pressure rating.
Always
make
sure
regulators, pressure relief valves, gauges, etc.
are working properly before starting system or
assembly.
Verify
dampener
purchase order and shipper.
Before starting a system or assembly make
certain the discharge point of the piping system is
clear and safe, and all persons have been warned
to stand clear.
DO NOT put your face or body near dampener
when the system or assembly is operating, or
dampener is pressurized.
S
AFETY
G
ENERAL
If serial tag is
use
dampener
without
safety
shutoff
valves,
model
received
against
BLACOH F
S
YMBOLS
S
AFETY
DO NOT operate a dampener that is leaking,
damaged,
corroded
contain internal fluid, air or gas pressure.
DO
NOT
pump
dampener.
Consult distributor or factory if you
are not sure of the compatibility of system fluids
with dampener materials.
Dampeners
are
compressed air or clean dry Nitrogen only. Other
compressed gases have not been tested and may
be unsafe to use. DO NOT USE OXYGEN.
Always shut off air supply, remove internal
dampener pressure, and shut dampener isolation
valve before performing dampener maintenance
or repair.
Remove
all
pressure
pumping system before disassembly, removal or
maintenance.
Static spark can cause an explosion resulting
in severe injury or death. Ground dampeners
and
pumping
flammable fluids or operating in flammable
environments.
NOTE:
EC standard EN-13463-1 and EN-
13463-5 (ATEX) require grounding (earthing)
on dampeners when the potential for static
sparking is present.
located
and
dampener models.
C
, I
.
LUID
ONTROL
NC
SAFETY W
ARNINGS
or
otherwise
unable
incompatible
fluids
through
designed
to
operate
from
dampener
system
when
pumping
A grounding point is
marked
on
ATEX
specific
to
with
AND
2