Blade 350 QX3 Manual de instrucciones - Página 13

Navegue en línea o descargue pdf Manual de instrucciones para Cuadricópteros Blade 350 QX3. Blade 350 QX3 16 páginas.
También para Blade 350 QX3: Manual de instrucciones (16 páginas)

Imprimir página

Calibration Procedures

North

Rudder right

Bind in pressure calibration mode

Compass calibration procedure:

NOTICE: The following procedure has to be

completed within 30 seconds after entering compass

calibration mode.

1. P ower the transmitter.

2. P ower on the 350 QX3 and face the

quadcopter pointing North.

3. C ycle the top left transmitter switch completely

4 times as shown at the left.

4. T he 350 QX3 indicates it has entered compass

calibration mode by slowly flashing the LED orange.

5. W hen the LED begins to flash rapidly, complete

all 4 rotations of the 350 QX3 as shown in the

illustration at left within 30 seconds, rotating the

quad 45° counterclockwise between each rotation.

6. H old the quad level, facing North and check the LED.

Green = Ready

Red = Repeat Compass Calibration

Accelerometer calibration procedure:

1. P ower on the transmitter and 350 QX3 and

place the quad on a flat, level surface.

2. W hile holding the bind switch on the transmitter,

cycle the top left switch 4 times as shown at the left.

3. T he 350 QX3 will emit a series of slow tones

followed by a series of rapid tones, indicating the

calibration has started.

4. D o not move the 350 QX3 while it performs the

accelerometer calibration procedure.

5. W hen the procedure has completed, the 350 QX3 will

emit a "happy" tone and the LED will display green

indicating the calibration was successful. If it emits a

"sad" tone and the LED displays solid red, repeat the

calibration procedure.

Pressure Sensor Calibration

The pressure sensor is calibrated at the factory on the

350 QX3. Recalibration should only be necessary if you

replace the sensor.

1. P lace the 350 QX3 in a cold area. Allow it to remain

in the cold for 30 minutes or more.

2. B ring the 350 QX3 out of the cold and into a warm

area. The greater the difference in temperature

between the cold and warm areas, the more accurate

the calibration will be.

3. E nsure your transmitter is off and then connect a

flight battery to the 350 QX3Power the 350 QX3 ON

and let it initialize. The status LED will remain off.

4. Hold the 350 QX3 upside down until the status LED

flashes blue, indicating it has entered bind mode.

5. Set the quadcopter back upright.

6. B ind your transmitter to the 350QX3 with the rudder

stick fully to the right. The LED will blink red and blue

rapidly. Leave the aircraft and transmitter powered

on and allow the aircraft to warm up for 10 minutes.

Do not move the aircraft during this time.

7. A fter 10 minutes the motors on the aircraft will beep

to indicate the calibration is complete. Power off the

aircraft and then your transmitter.

If the 350 QX3 displays the failed calibration code, power

off the aircraft and then begin the pressure calibration

procedure again.