Blade Scimitar LRX Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Drones Blade Scimitar LRX. Blade Scimitar LRX 13 páginas.

Installing the Flight Battery

1. Set the motor arm switch to OFF (position 1).

2. Lower the throttle.

3. Power on the transmitter.

4. Attach hook material to the quadcopter frame and loop

material to the battery.

5. Install the flight battery on the quadcopter frame and

secure it with the hook and loop strap.

6. Connect the battery cable to the aircraft power lead,

noting correct polarity. Do not move the quadcopter until

the receiver initializes.

CAUTION: Always disconnect the Li-Po battery from the quadcopter when not flying to avoid over-discharging the

battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged, resulting

in loss of performance and potential fire when batteries are charged.

To bind or re-bind your quadcopter to your chosen transmitter, follow the directions below.

Binding Procedure

1. Select the correct model in your transmitter.

2. Power off your transmitter.

3. Lower the throttle fully.

4. Power the quadcopter on while pressing the bind button on the left side of

the flight controler, as shown in the illustration.

5. Follow the procedures of your specific transmitter to enter Bind Mode.

6. The receiver LED glows solid orange indicating binding was successful.

If you encounter problems, obey binding instructions and refer to the

troubleshooting guide for other instructions.

If needed, contact the appropriate Horizon Product Support office. For a

list of compatible DSM

transmitters, please visit www.bindnfly.com.

Failsafe

The included receiver does not have failsafe capabilities. Failsafe is detected at the flight controller. In the event of a loss of signal

to the receiver the flight controller will cut power to the motors to prevent a fly-away situation.

CAUTION: Connecting the battery to the aircraft

power lead with reversed polarity will cause

damage to the power distribution board, ESCs and the

battery. Damage caused by incorrectly connecting the

battery is not covered under warranty.

7. The quadcopter motors will emit initialization tones,

indicating the ESC is armed.