Discount Car Stereo A2DIY-GM3 Manual de instalación de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de instalación de inicio rápido para Sistema estéreo del coche Discount Car Stereo A2DIY-GM3. Discount Car Stereo A2DIY-GM3 8 páginas. Bluetooth for select 2000-07gm class -ii radios

Imprimir página

Optional push button with built-in microphone:

This option replaces standard visor microphone and separate push button

shown in Fig. 5 and 6, and combines both into a single button. (See images

below) and installed to dashboard within driver reach or custom installed

nearby.

To install simply connect 1/8" plug to module "MIC/CTR" jack (See Fig. 3),

route to dash area (cable is 6ft. long); clean surface, remove tape backing and

secure to dash.

Red wire

on installation harness must be connected to a 12V Accessory

supply in vehicle.

Avoid connecting this wire to 12V constant supply

(battery).

Tip: Accessory (ACC) supply available on BROWN wire (Most GM's) under

steering column or on climate control harness or in driver side fuse panel.

Always use voltmeter to verify voltage and check for engine noise prior to

finalizing.

Accessory power is active when ignition is in "ACC" or "ON "positions.

USB "fast charging" Option:

An optional USB charging port can be added to your module. Should you decide

on this add-on, we suggest one of 2 connecting options:

A. Flush to dash/panel requires drilling a ¾" hole

B. Flush with Support bracket (Mount USB terminal wherever your installation

demands without drilling)

Flush to Dash or Panel

Drill a ¾" hole in the dash or panel using a step drill bit or equivalent

(See Fig. 10)

Step drill bit

Insert male terminal from supplied 3ft. cable (See Fig. 11) through hole

created in step 1 and connect to installation harness charging port (See

Fig. 12)

(not for thumb drives etc.)

(drilling required)

Fig. 10