Cub Cadet CC 2000 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Recortadora Cub Cadet CC 2000. Cub Cadet CC 2000 20 páginas. 2-cycle trimmer
También para Cub Cadet CC 2000: Lista de piezas (2 páginas)

Imprimir página
Cub Cadet CC 2000 Manual del usuario
Section 5
Operation
J
Start/
On (I)
Fig. 5-1
Stop/
Off (O)
\
\
\
\
\
On/Off Stop Control
Choke Lever
Primer Bulb
Fig. 5-2
Starter Rope
Fig. 5-3
STARTING
INSTRUCTIONS
t
i =' _, k
L
Operate this unit only in a well ventilated
area
outdoors.
Carbon
monoxide
exhaust fumes can
be lethal in a confined
area.
Avoid accidental
starting.
Be in the starting
position whenever
pulling the starting rope. To
avoid serious personal
injury, the operator
and
unit must be in a stable position while starting.
STARTING
INSTRUCTIONS
1.
Mix gas with oil. Fill fuel tank with fuel/oil mixture.
See Section 4, Oil and Fuel.
2.
Put the On/Off Stop Control in the START (I)
position (Fig. 5-1).
.
Fully press and release primer bulb slowly 5 to 7
times. Fuel should be felt and visible in the bulb
(Fig. 5-2). If fuel hasn't entered the bulb, press
three more times, or until it does.
4.
Place the choke lever in the START (A) position
(Fig. 5-2).
5. With the unit on the ground, squeeze the throttle
control and hold. Pull starter rope briskly (Fig. 5-3).
Continue pulling until the engine sounds as though
it wants to run (normally 2 to 5 pulls).
NOTE: Squeeze the throttle
control
until the engine
has started and warmed
up.
6.
Place the choke lever in the RUN (B) position
(Fig. 5-2).
7.
Pull starter rope briskly 1 to 3 times to start the
engine (Fig. 5-3).
8.
If the engine does not start, repeat steps
4 through 7.
NOTE: If the engine floods while trying to start,
place the choke lever in the RUN (B) position.
Squeeze the throttle control. Pull the starter rope
briskly. The engine should start within throe (3) to
eight (8) pulls.
9.
Squeeze the throttle control to warm up engine for
5 to 10 seconds. Place the choke lever in the RUN
(B) position (Fig. 5-2).
NOTE: Choking is unnecessary when starting a
warm engine. Put the On/Off Stop Control in the
START (I) position (Fig. 5-1), and the choke lever in
the RUN (B) position (Fig. 5-2).
STOPPING
INSTRUCTIONS
1.
Release your hand from the throttle control
(Fig. 5-3). Allow the engine to idle.
2. To stop the engine, put the On/Off Stop Control in
the STOP [O] position (Fig. 5-1).
10