BLADEZ PB-SM 818 Manual del producto - Página 7

Navegue en línea o descargue pdf Manual del producto para Scooter BLADEZ PB-SM 818. BLADEZ PB-SM 818 15 páginas. Electric power board

Installing the Handle Bar

Before using your XTR-COMP II, loosen the

4 bolts from the Billet Aluminum Stem with

the Allen Wrench provided, and then remove

the stem cap as shown in Fig 1.

Place handle bar onto the Billet stem with the

hole facing down towards the threaded bolt

as shown with arrow in Fig 2.

Place the Billet Stem cap on top of the handle

Fig. 3

bar and tighten the bolts to secure the handle

bar onto the stem as shown in Fig 3.

Quick Release Deck

Intergraded Seat Base

The XTR-COMP II comes with a seat base

built in to the scooter. Having this base built in

to the Scooter will make it easy to install and

remove your seat. To install the seat, remove

the pin from the side of the scooter. (Fig. 5)

Then place the seat post into the base on the

deck (Fig.6) and replace the pin in the side of

the scooter to secure the post. Place the seat

The XTR-COMP II has a quick release

deck which makes it easier to gain access

to the batteries and the pc board. To

open simply lift up from the rear of the

deck and it will open up towards the

handle bar. (Fig. 4)

Page 7