Discount Displays STDRD-MONITOR STAND Instrucciones de instalación
Navegue en línea o descargue pdf Instrucciones de instalación para Bastidores y soportes Discount Displays STDRD-MONITOR STAND. Discount Displays STDRD-MONITOR STAND 3 páginas.
Imprimir páginaFRAME
Step 1: Assemble 3-part Vertical Supports (A) with plastic grommets facing out.
Step 2: Using the Hand Tool (B), attach the top and bottom Horizontal Supports
(C) to the Vertical Supports (A) by turning the screw with the star-shaped hole
clockwise.
NOTE: Make sure the thin groove is along the outer edge of each piece so the
groove is continuous around the frame.
Step 3: Using the Hand Tool (B), attach the Cross Supports (D) in the same man-
ner at the 2 joints in the Vertical Supports (A).
NOTE: The 3rd Cross Support (D) is included for added support or for use as a
spare replacement piece.
GRAPHIC
Step 1: Make sure the frame is laying flat on the floor and the star-holed screws
are facing down.
Step 2: Start with each corner and attach Fabric (F) by rolling fabric in and push-
ing the rubber beading into the thin groove along the edge of the frame with your
thumb.
Step 3: After the corners are secured, continue pushing the rubber beading into
the groove along the sides, top and bottom of the frame.
NOTE: The corners of the stitching should be at the corners of the frame. Over
stretching the fabric will result in uneven bunching of the fabric. Pull the
fabric just tight enough to lay flat.
Step 4: insert assembled frame and graphic (with the print facing torwards the
long side of the base) onto the posts of base.
STDRD-MONITOR STAND
C
D
ASSEMBLE
(A) vertical supports
A
A
D
(D/A) middle supports
C
F
CONNECT
corners together (A/C)
INSERT
LOCK
(B) with hand tool