ARNETOLI MOTOR F 202 BV Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Accesorios para cortacéspedes ARNETOLI MOTOR F 202 BV. ARNETOLI MOTOR F 202 BV 2 páginas.

Imprimir página

- How to change the trimmer line

Changing the trimmer line is a simple operation. Be sure you use a quality trimmer line, otherwise your line will break often

and create unnecessary hassles. We recommend you use our MAXI-LINE - a high resistant line which not only increases the

effectiveness of the brush cutter head but also eliminates any chance of the line getting stuck together.

1 Unscrew the bottom part of the

head using the apposite wrench

4 Reel the same lines in the middle of

the spool and wind

7 When finished rolling up the line, place the

line in the retainer slits to keep it from unra-

velling (its recommended to leave at least

4 inches of line to ease step number 8)

- If the line doesn't come out

This can be caused by any of the following reasons.

• Has the line been wound up correctly, without crossing over (fig. 6)?

• Once the outer reel was replaced, did you pull and remove the lines from the retainer slits (fig. 9)?

• Is the trimmer line used of poor quality?

• Is it blocked because the knob is dirty?

Remember that proper maintenance and an occasional cleaning of this tool will not only prolong its' life but also prevent product failure.

aution

For maximum operator safety, before starting work, in addition to the

deflective shield, we recommend you wear a face shield, one of many

quality accessories offered by ARNETOLI MOTOR.

ARNETOLI MOTOR S.R.L. - Via Ponte all'olivo - 50066 Reggello (FI) ITALY Tel. +39. 055. 863484 - Fax. +39. 055. 863485 - e-mail: [email protected] - www.arnetolimotor.it

2 Take off the outer reel

5 Overturn the spool and wind up in the direction

as indicated by the arrows on the side

8 Re-insert the outer reel on the

housing

3 Insert the lines in the inner

retainer holes

6 The lines must be wound up parallel with each

other and must not cross over each other

YES

9 Once the line is in place, pull the lines

outwards to release them from the slits

YES