Discount Equipment SS-16 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Sierra Discount Equipment SS-16. Discount Equipment SS-16 9 páginas.

Imprimir página
I
I
@)
WATER FLOW- BLADE SAVER SWITCH OPERATION
FIGURE #1
0
@
E-SS-16/18-IE-2/98
1 .......... Depth Control Hand Crank
2 .......... Drive Selector Lever
3 .......... Speed Control Knob
4 .......... Throttle
5 .......... Stop or Ignition ON/OFF Switch
6 .......... Water Flow - Blade Saver Switch
7 .......... Electric Water Pump Switch
(Optional)
8 .......... Water Hose Connection - Valve
9 .......... Handles (Adjustable)
10 ........ Clutch Cam Lever
11 ........ Adjustable Handle Position Lock
12 ........ Choke Cable Knob
13 ........ Hour Meter -or-Amp. Meter
(Optional)
14 ........ Depth Indicator Gauge (Optional)
15 ........ Oil Alert Light (Optional)
16 ........ Gasoline Fill Cap (Model SS-18)
1. On all models, the "Water Safety Switch" must be in "START-DRY CUT" position or the engine will not start.
2. The purpose of the Water Safety Switch is to STOP engine if water pressure drops.
3.
NOTE: Water Safety Switch detects pressure and cannot.detect a clogged line between supply and coolant outlet in
blade guard ... check to be sure water flows freely and is no1 obstructed.
4. When cutting DRY, leave switch in START-DRY CUT position.
5. When cutting WET, attach supply hose to Water Hose Connection Valve.
6.
NOTE: For units with the optional water pump, water flows through the pump assembly at all times.
7.
If pressure from outside source, such as city water supply is adequate (2 Y, to 5 gallons per minute) optional water
pump need not be engaged.
8.
With water flowing through the system freely, and engine running, change position of the Water Safety Switch to the
WET CUT position. You have now activated the water control system.
9.
Should the engine stop at this point, there is probably not enough water flowing through the blade cooling outlet.
Check supply source:
a.
Is city water valve open full?
b.
Is valve on saw console open?
c.
If you are using gravity feed, check the flow.
d.
After fixing the water supply problem, return the Water Safety Switch to START-DRY CUT position.
e.
Restart engine, following directions in the ENGINE STARTING section.
f.
For saws with the optional water pump: engage the water pump; turn the Water Pump Switch to "ON".
g.
With engine running, change position of Water Safety Switch to WET CUT . .
h.
Engine should continue to run.
OPTIONAL ELECTRIC WATER PUMP OPERATION
1. On all models equipped with electric pumps (12 V.D.C.), be sure there is water in the system AND water is being
supplied to the pump. Open all water valves before turning on the pump.
2.
Turn the Electric Water Pump Switch (7) ON.
3.
Never interrupt the flow of water to the pump while the pump is ON.
4.
CAUTION: Stopping the flow of water to or from the pump while it is ON will cause the pump fuse to blow.
5.
To stop water flow, FIRST turn the Electric Water Pump Switch (7) OFF, then close all water valves.
5