3d XPRO 490 Manual del usuario - Página 16

Navegue en línea o descargue pdf Manual del usuario para Barco 3d XPRO 490. 3d XPRO 490 17 páginas.

When first coat is dry to the touch (about 10 to 15 minutes) apply a second thin coat. After

waiting 5 or 6 minutes, touch the adhesive with the back of your hand. If it no longer appears

wet, heat both areas with a hot air gun to re-activate the glue and join the patch to the tube and

then clamp or roll the surfaces together. For the best adhesion, roll over the patch with a roller

or over the bottom edge of a bottle.

Do not inflate the boat fully for 24 hours.

Repair Hypalon boats

3D Tender boats that have tubes constructed dwith Orca Hypalon coated fabrics cannot be

bonded with plastic adhesive or by welding. They require neoprene based glue and RFE harden-

er. MEK solvent is recommended to prepare the surface before gluing. Use only recommended

solvent and adhesice.

Identify the area to be patched. This can be done by running water over the suspect area or

spraying or brushing with soapy water..

If the hole is only small, cut out a round patch of no less than 60 mm diameter. Larger holes or

cuts will require proportionately larger patches but always ensure you have at least 30 mm of

patch around the perimeter of the cut or hole and the corner are well radiused.

Next hold the patch on the tube and mark out around it with a pencil.

Use a grinder, course sand paperor scratch stone, rough up both the back of the patch and the

area marked on the tube.

Clean both surfaces with solvent and spread a thin layer of adhesive over them ensuring there

are no lumps.

When first coat is dry to the touch (about 10 to 15 minutes) apply a second thin coat. After

waiting 5 or 6 minutes, touch the adhesive with the back of your hand. If it no longer appears

wet, heat both areas with a hot air gun to re-activate the glue and join the patch to the tube and

then clamp or roll the surfaces together. For the best adhesion, roll over the patch with a roller

or over the bottom edge of a bottle.

Do not inflate the boat fully for 24 hours.

Danger

Glue and solvents used for repair are highly flammable. Perform repairs in a well ventilated

area. Avoid breathing the vapors, wear protective gears (goggles, filter respirators, latex

gloves.)

Upholstery

3D TENDER is using marine grade upholstery fabric to offer best resistance to UV and ageing.

Periodic washing with mild detergent and warm water is the best way to keep your upholstery

look good. Special vinyl cleaner can also be used to remove difficult stains. No fabrics can last

forever when constantly exposed to the elements. We therefore recommend you to cover your

boat when not in use.