DiscountRamps Silver Spring ESC400 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Silla de ruedas DiscountRamps Silver Spring ESC400. DiscountRamps Silver Spring ESC400 9 páginas. Deluxe electric powerchair and scooter carrier

DiscountRamps Silver Spring ESC400 Manual de instrucciones

Section 4: Installation

Your powered mobility lift is shipped in the box as factory pre-assembled. Once the vehicle wiring
harness is connected, the lift can be installed to the vehicle hitch with help of the battery.
Measure from the bottom of the vehicle hitch to the ground to determine the orientation of the hitch
adapter based on the vehicle's hitch ground clearance.
15" - 20"
Measure from bottom of
10" - 15"
hitch receiver to ground
Non-Powered Method
Bolt the hitch adapter to the powered mobility lift with (2) bolts,
(4) washers, and (2) nuts using the measured orientation.
Move the folded lift to the rear of the vehicle with the motor box
folded down and away from the vehicle. It's highly recommend-
ed to have at least two people lift the unit upward and place it
into the vehicle hitch receiver. While holding the mobility lift in
place, secure it to the hitch receiver with a hitch pin or pinch
bolt.
Powered Method
Install the hitch adapter into the vehicle hitch receiver using the
orientation obtained from measuring, secure with hitch pin or
pinch bolt.
*Hex bolts MUST be at least one hole
away from each other
Place the mobility lift at the rear of the vehicle with the motor
box folded down and away from the vehicle.
Plug the wiring harness previously installed in the vehicle, into
the mobility lift. Turn the key and use the toggle DOWN switch
to raise the motor box toward the hitch adapter. Continue to
power the lift until the mounting holes line up with the hitch
adapter.
Bolt the mobility lift to the hitch adapter with (2) bolts, (4) wash-
ers, and (2) nuts.
Routing the Power Cord
Route the lift power cord down the lift, away from moving parts. The cord should follow along the mo-
tor box post and be secured with zip ties to allow the lift to operate without disconnecting or pinching
the power cord.
Rev. 061218
Page 4
DiscountRamps.com • 1-888-651-3431