3D Hobby Shop 70 AJ SLICK Manual de montaje - Página 18

Navegue en línea o descargue pdf Manual de montaje para Juguete 3D Hobby Shop 70 AJ SLICK. 3D Hobby Shop 70 AJ SLICK 19 páginas.

Balancing: The AJ Slick can use a wide range of center-of-gravity locations. For your maiden, we

suggest a more forward CG location, since you can always move your CG rearward to suit your flying

For maiden and precision flight - 155-160mm from leading edge of wing at root

This is approximately the forward edge of the carbon wing spar tube.

When trimming your CG, keep in mind that a "neutral" CG (one with which you can roll the airplane

inverted and the airplane neither climbs nor dives) is good for 3D aerobatics, but a more forward CG (one

with which you must hold some "down" elevator to keep the airplane flying straight while inverted) is often

better for precision flight and is much easier to land gracefully.

Control Throws - Throws are given both in degrees and in millimeters, measured at the end of the

surface (where the throw is greatest). A throw meter is included to measure these angles.

Ailerons-

Low Rate 15 degrees

High Rate 30 degrees

Elevator-

Low Rate 15 degrees

High Rate Maximum possible throw, at least 45 degrees 75% exponential

Rudder-

Low Rate 30 degrees

High Rate 45 degrees

Make your first flight with the controls set on low rates. During the trimming phase, we recommend

landing with some throttle, and not attempting to "dead stick" the airplane. This may mean you need to

time your flights and keep them a bit shorter than usual. After your first flights, check all control

connections and motor and prop mounts for tightness.

style if necessary.

30% exponential

70% exponential

30% exponential

75% exponential