CUBEX SKYMASTER III- 3B Manual - Página 12

Navegue en línea o descargue pdf Manual para Antena CUBEX SKYMASTER III- 3B. CUBEX SKYMASTER III- 3B 13 páginas. Quad antennas

Instructions:

ADDENDUMS

Reflector / Director

Connections - splice

or crimp sleeve

Locate the small bag of crimp sleeves (5 +1spare).

After completing the wiring of the Reflector and Director elements the ends must be connected to

complete the Quad loop. Slide both ends through the sleeve as shown in fig 3b. Pull wire

through to eliminate the slack in the wire. Temporarily fold each wire end as above to hold the

wire position. Check the tension in all of the sides of this element, making sure that the arms are

"square" and in line. Make an adjustment at the sleeve and if satisfied Crimp, or solder the

element wire into the sleeve. This technique allows you to get the element wire tension correct

without committing to a wire wrap or crimped connection.

Cubex Engineering

Cubex Co., Inc.

Cubex SkyMaster Series

Joining Element Wires

Crimp sleeve

Pull wires through sleeve and bend

to temporarily hold position

Trim wire ends after

completing adjustment of

tension

Alternate method-

"Line men's" Splice

Fig. 3b

Typical cable

dressing for direct

feed of quad.

Pg. 12

Fig. 3a

Element Wires -

Antenna

Switch

Boo

Mast

05-06 Rev 0

6" dia Coil

Excess Cable