CubiScan 110-XT Configurar - Página 2

Navegue en línea o descargue pdf Configurar para Instrumentos de medida CubiScan 110-XT. CubiScan 110-XT 2 páginas.

Imprimir página
3
Slide back panel on and secure
B
Loosen Phillips screws, slide back panel (A)
down, tighten screws
Attach top sensor
5
K
Use included 4mm Allen wrench to secure
socket head cap screws and lock washers (K).
Set up display
7
1
Locate the green-ended tethering cable coming from under the
front of the platform. Plug the cable into its green port
below the screen on the freestanding display (C).
2
Locate the power cable and plug it into its port.
3
Orient the display so that it faces the operator. The preferred
method is to bolt the display to a Cubiscan cart as shown.
The display may also be clamped to the pole of the cart's laptop
attachment, or it can be placed on an adjacent table or desk.
Copyright© 2021 by Quantronix, Inc.
All rights reserved.
4
A
A
Lock nuts (I) attaching sen-
sor bracket (D or E) to back
6
F
Plug cables into receptors
Display bolted
to cart
Attach side sensors
I
D or E
plate (A)
Note: Avoid touching the delicate gold foil on the sensors.
Connect sensor cables
on sensors (D or E),
clicking them in place.
configuration
801.451.7000
cubiscan.com
(repeat with the
other side sensor)
I
D
E
or
Phillips screws (J)
A
B
Thread cable through
backplate channel from
below back center of scale
platform (B), and plug into
top sensor (F).
Cart mount
configuration
Post mount
configuration
Desk mount
B
J
F