Abble 300571 Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Pino artificial Abble 300571. Abble 300571 2 páginas. 8ft. green lighted flocked spruce artificial christmas tree

Imprimir página

PRE-LIT TREE ASSEMBLY INSTRUCTIONS:

1. Follow the stand assembly instructions to set up the tree stand.

a. Pull apart the legs of the stand so that they are X-shaped.

b. Screw the eye bolts through the hole of metal tabs. Turn screws so

they touch tree trunk. Stand tree up and straighten by adjusting

screws in or out then tighten screws.

2. Set section C to stand. Take all the hinged branches to unfold into

place. (See Fig. 1)

3. Shape the branches on the bottom section of your tree. Note that some

tree models have "side branches" attached to the main branch stem

that require additional shaping.

4. Set the middle section B of tree into bottom section. (See Fig. 2) Take

all the branches to unfold into place. Shape the tree to a full look.

Connect plug (B1) to end plug (C2).

5. Insert tree top A into the hole (pole cap) on the top of the trunk of

middle section.(See Fig.2) Take all the branches to be shaped.

Connect the plug (A1) on the light set on the tree top section into the

end-plug (B2) of the strings of middle section. Shape the branches on

the tree top section.

6. After shaping the whole tree following the previous steps, step back

and take an overall look at the tree. Shift branches as necessary to fill

any gaps.

7. Now you can plug the C1 to a standard power outlet to perform the

tree for decoration.

8.After the installation is complete, use a vacuum cleaner to clean up the

snow powder on the floor.

TROUBLE SHOOTING:

If your tree does not light up, please check the following.

1. Check that all plugs are properly connected.

2. Check wall outlet for power.

STORAGE:

Unplug the product from the wall outlet and remove all ornaments and decorations.

(Except for decorations attached at manufacturer.)

Unplug each section of extension cord, keep each stack of lights connected together.

Gently lift off the top and middle sections, and remove the bottom section from the tree

stand. Carefully replace the tree in its box and tape it shut.

DO NOT STORE TREE IN A DAMP AREA OR IN AN AREA WHERE

THE TEMPERATURE EXCEEDS 100 F.

Fig. 2

Fig. 1

2/4

Eye Bolts

To Power Supply

Eye Bolts

3/4