Dish Network SoloDVR ViP 612 Configuración del mando a distancia - Página 3
Navegue en línea o descargue pdf Configuración del mando a distancia para Mando a distancia Dish Network SoloDVR ViP 612. Dish Network SoloDVR ViP 612 15 páginas. Dish network remote control
Imprimir página
1
Press and hold the SAT mode button for three seconds, until all of the mode buttons light
up, and then let go of the SAT button.
2
Press POUND (#) twice. The SAT mode button will flash the same number of times as the
address number (for example, three flashes means address 3).
Confirming Remote Control Operation
1
Make sure the remote has fresh batteries and is in SAT mode.
2
Press SYSTEM INFO on the receiver front panel to display the system information screen.
3
Press RECORD on the remote control:
•
The Remote Address in the system information screen changes to match the address
preset in your remote control.
4
Press POWER on the remote control to turn on/off receiver.
Changing the Remote Control from UHF Pro to IR
Your receiver accepts both UHF and IR (Infrared) commands. The remote control only
outputs UHF Pro signals but can be changed to transmit IR commands by switching the
key at the bottom. This is also useful for programming an after-market universal learning
remote control to operate your receiver. Note that when the remote control is in IR mode,
you will need to use it from the same room to operate the receiver because IR signals do
not travel through walls or over great distances.
Remote Control Setup
Model ID
ViP612 CVR-SD
Receiver CAID
R0079256789-30
Smart Card ID
S1907972574-12
DNASP206 Dsh689
Software Version
AEE2WAND-N
Boot Strap Version
1010WAND
Billing & Programming
1-800-333-DISH(3474)
Technical Assistance
1-800-333-DISH(3474)
Internet Address
dishnetwork.com
Receiver Mode
Single Mode
Location ID
87940875:00000004
Remote Address
IR/UHF Pro Band A
Help
Done
Cancel
Improving Receiver Control
63