CubuSynth Engine V2 Manual de construcción - Página 6
Navegue en línea o descargue pdf Manual de construcción para Sintetizador CubuSynth Engine V2. CubuSynth Engine V2 11 páginas. Dual complex vco with wave shaping and modulation features
Imprimir páginaCubuSynth Engine V2 - Build Guide
STEP 6
LEDs
12
LED-TH-3mm_W
8
LED-TH-3mm_CLR
20
LED-Spacer 4mm
First place the LED spacers on the white LEDs like this
Then insert all white LEDs on their spots around the switches.
For the LEDs, orientation is important! The longer leg goes in
the upper hole, while the flat side of the LED points down.
Only solder 1 leg of each LED! Then check all LEDs, they should
stand vertically to the PCB. Adjust if necessary.
Then solder the remaining pins.
For the colored LEDs it is recommended to put the spacer and
place the LEDs individually to not swap colors.
This is the PCB with all LEDs in place.
Page 6
LED1..........LED12
RED,PINK,PURPLE,BLUE,GREEN,Y-GREEN,YELLOW,ORANGE
SMD-PCB V1.1 Jul 2023