Dish Network DISH 1000 Manual de instrucciones de instalación - Página 7
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Antena Dish Network DISH 1000. Dish Network DISH 1000 16 páginas.
También para Dish Network DISH 1000: Manual (18 páginas), Manual (20 páginas)
Imprimir página
Remove the temporary cable used for peaking the dish. Thread the cable(s) from the receiver(s)
through the LNBF arm and 119°W slot of the W-Bracket. Connect these cables to
, as applicable.
P
2
ORT
Thread the loose end of the 5-1/2 foot long cable through the LNBF arm and 110°W slot of the W-
Bracket. Connect to the
Twin LNBF to the W-Bracket with two screws.
: Make sure to loop the 5-1/2 foot long cable in a circle as shown in Figure 1 on page 2.
Note
Connect the receiver(s) to the TV(s) and display the
press MENU-6-1-3 on the remote control). Make sure the software version meets the requirements
on the Table 2. If the receiver has older software, go to Special Downloading Instructions on page 7.
If the receiver has the required software, continue on to the next step in this procedure.
Table 2. Software Required for Dual-Tuner Receiver Installation
DISH 322
DISH Player-DVR 522
DISH 721
DISH Player-DVR 921
Legacy Tuners
Single Tuner DISH Pro Receivers
DISH Player-DVR 625, DISH Player-DVR 942, and future DISH Pro Plus Dual-Tuner
Receivers
Connect a cable from DISH Pro Plus Twin LNBF
DISH Pro or DISH Pro Plus satellite receiver's
(a Legacy receiver will be installed later in this procedure, if necessary). For
DISH Pro Plus dual-tuner receivers with a single cable, install a DISH Pro
Plus Separator as follows:
a. Connect a cable from the DISH Pro Plus Twin LNBF output (
or
1
P
ORT
b. Connect cables between the receiver's
S
ATELLITE
Separator.
port on the DISH Pro Plus Twin LNBF. Attach the DISH Pro Plus
LNB I
N
Receiver
) to the DISH Pro Plus Separator Input.
2
to
and
I
2
P
1
2
N
ORTS
You must use a DISH Pro Plus Separator in this installation. A splitter or other
device will not work in this configuration.
Tighten all indoor coaxial cable connections to the receiver only by hand. If you
use a wrench, you may over-tighten the connections and damage your equipment.
System Information
L054 or later or current download
L059 or later or current download
Current download
L052 or later or current download
All
All
All
(or
P
1
P
ORT
connection(s)
S
I
ATELLITE
N
and
S
I
1
ATELLITE
N
respectively on the DISH Pro Plus
P
ORT
screen (for most receivers,
Software Version
) to a
2
ORT
P
ORT
and
1
Page 5