Aroma360 Mini360 2.0 Instrucciones - Página 4

Navegue en línea o descargue pdf Instrucciones para Accesorios Aroma360 Mini360 2.0. Aroma360 Mini360 2.0 5 páginas.

c. Underneath the days of the week, you would see two sets of hours and minutes. This

represents the time it will turn on the unit to mist and the time it should stop misting.

This again runs on a 24hr time frame. For example: if you wish to have it mist from 12 -

3:15pm; the first time is 12:00 while the second time would be 15:15.

d. Once you have established a time, you will then adjust the running time and pause time.

This can run from a 5 second interval to 300 seconds. We recommend as the lowest

running time as 15 seconds; this will allow enough time for the diffuser to pull the oil,

atomize it and create a mist. (We have a recommended chart if you are unsure what

time to set)

e. Last, to save your setting – you will press the check mark above the SUN (Sunday

abbreviation) to save this setting

11. You will repeat these steps if you wish to have multiple times you want your diffuser to mist.

Wifi Mode:

1. Make sure you are next to your unit and can download the ScentArea app with an updated

cellphone.

2. Open the app, click through the questions – be sure you allow to use location while using the

app and to use local network as well.

3. Click on Wifi mode; it will state to log in. You will register your phone number (free sign-up if

this is the option you see).

4. Once you click to register, a new window will appear, and you must type in your cell number to

receive a SMS code. Keep in mind to change the country code to the correct country for your

phone number.

5. When you receive the country code, type in the code underneath your phone number and hit

NEXT (it may appear as another name depending on iPhone or Android you have)

6. A new screen will appear to create a password – this password needs to have letters and

numbers, minimum of 6 charters (hit next once you have created a password you will

remember)

7. The new screen will appear to either scan or Add Equipment – you will press Add Equipment

8. This will go to a screen where you will see that you are connected to YOUR Wi-Fi and asks for

you to enter that password (please be sure you know your password).

9. Type out the password -> then press and HOLD the MODE button on your diffuser until you hear

it beep about 4x's (let go) -> once you hear it beep, press START CONFIGUREGATION on the app.

*This step may have to be repeated if the password was typed incorrectly or you did not press

the mode button in time.

10. It takes about a full minute to connect, and you should see a prompt that appears and says

connection successful (it may differ depending on the iPhone and/or Android)

11. You will then hit the back button to where you saw Scan or Add Equipment. Underneath those

option, Device01 should appear as an option now – click on that option.

12. Once you click on Device01, a new screen will appear, and you should see the following options:

a. Running state: turns on and off the unit

b. Fan: do NOT switch off, always leave on

c. Device Lock: locks the buttons on your diffuser from responding by touch

d. Working Mode: this is the option you select when you are ready to program your unit