Dish TV S9040DVD Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Reproductor de DVD Dish TV S9040DVD. Dish TV S9040DVD 14 páginas. Dvd/dvb-s2 combo player with hdmi output

Imprimir página

4.2 Video Setting

To access the Menu, press MENU then select [Picture]. The Menu provides options to

adjust the video settings. Press UP/DOWN to select an option and press RIGHT/LEFT to

adjust that setting. Press EXIT to exit the menu.

4.2.1 Aspect Ratio

You must set the display format to either 4:3 Pan Scan, 4:3 Letter Box,16:9 Wide Screen or

Auto to get the maximum display when watching TV.

4.2.2 Resolution

If the video does not appear correctly, change the

setting. This setting is to match the most common

setting for HDMI. [480i]: for NTSC system TV. [480P]:

for NTSC system TV. [576i] for PAL system TV.

[576P]: for PAL system TV. [720P]: for NTSC or PAL

system TV. [1080I]: for NTSC or PAL system TV.

4.2.3 TV format

If the video does not appear correctly, you need to

change the settings. This should match the most

common setting for TVs in your country.[NTSC]:

for NTSC system TV. [PAL]: for PAL system TV;

[Auto] :set TV format according to the stream automatically

4.3 Channel Search

To access the menu, press MENU and select

[Search Channel]. The Menu provides options to

adjust the Search Channel settings. Select an option

and press RIGHT/LEFT to adjust the settings. Press

EXIT to exit the Menu

4.3.1 Satellite

Configure the settings of satellites.

Satellites' list: Press Up/Down to select a satellite, whose settings will be shown at right

side.

LNB Type: Press LEFT/RIGHT/OK to show the list of LNB Types which is shown as

frequencies of local oscillator. You also can enter frequency by User Single, User Dual at

bottom of the list.

LNB Power: Press LEFT/RIGHT to set the LNB power.

22K: Press Left/Right to switch on or off the 22K,which is set with auto when LNB Type is

dual local oscillator.

Toneburst: Enable or Disable the toneburst switcher.

DiSEqC1.0: select the right port up to 4 for the right LNB.

DiSEqC1.1: select the right port up to 16 for the right LNB.

Motor: Press LEFT/RIGHT to select DiSEqC1.2 or DiSEqC1.3. Then Press OK to show the

menu to set position.

DiSEqC1.2: Move the motor to a right position to lock the signal.

DiSEqC1.3: Move the motor according to the local and satellite positions.

Move Auto: Press LEFT/RIGHT to start to move West/East. It will be stopped automatically

when the signal is locked.

Move Continue: Press LEFT/RIGHT to start to move West/East. It will keep moving until

you stop it.

Move Step[1]: Press LEFT/RIGHT to move just a step.

Store Position: store current position of motor.

Goto Position: Press LEFT/RIGHT to goto the position stored.

Goto Reference: Rest all the positions.