Distech Controls Allure EC-Smart-Air-C Manual de instalación - Página 3
Navegue en línea o descargue pdf Manual de instalación para Accesorios Distech Controls Allure EC-Smart-Air-C. Distech Controls Allure EC-Smart-Air-C 10 páginas.
Imprimir página
17
21
(0.67)
(0.83)
Figure 2:
Allure EC-Smart-Air- Back plate view
Mounting Instructions
This product has been specifically designed for easy installation. However, certain conditions apply when choosing a suitable location for the device:
£
The device should not be installed on an exterior wall.
£
The device should not be installed near a heat source.
£
The device should not be installed near an air discharge grill.
£
The device should not be installed in a place where it can be affected by the sun.
£
Install the device in an area that provides proper device ventilation. Nothing must restrain air circulation to the device.
£
Models equipped with a CO
The sensor has not been designed for outdoor use.
Installation Procedure
1. Remove the security screw from the device.
2. Open the device by pushing in the tab on its bottom and then by pulling the bottom side of the front plate out.
3. Make sure that the mounting surface is flat and clean.
4. Align the back plate with the wall and mark the location of the mounting holes on the wall. Make sure to orient the proper side of the back plate facing
upwards.
5. Remove the back plate and drill holes in the wall if necessary.
6. Install anchors in the wall if necessary.
7. Pull all RJ-45 cables 15 cm (6") out of the wall, and insert them through the central hole of the back plate.
8. Screw the back plate onto the wall. Do not overtighten.
9. Set the Subnet ID and the EOL termination with the DIP switch. See Setting the Allure EC-Smart-Air Sensor Subnet ID.
10.Connect the one or two RJ-45 cables into the sensor (reversible).
11.Gently push excess wiring back into the wall.
12.Reattach the front plate and make sure it clips tightly into place.
13.Install the security screw.
Connectors and DIP Switch Location
The Allure EC-Smart-Air Series sensors have the following connectors and onsite configurable DIP switches.
34 (1.34)
5 (0.20)
10 (0.40)
7 (0.28)
5 (0.20)
7 (0.28)
sensor must be used in spaces that are periodically unoccupied (e.g. during evening or nighttime hours).
2
56
58
(2.20)
(2.28)
82
(3.23)
3 / 10