Acoustic Energy 500 Series Manual - Página 2

Navegue en línea o descargue pdf Manual para Altavoces Acoustic Energy 500 Series. Acoustic Energy 500 Series 5 páginas.

Introduction

Congratulations on choosing the Acoustic Energy 500 Series. These are speakers of the

highest delity; designed to reproduce music at its purest, most natural, most enjoyable.

Please take a little time to read through this manual and follow, as far as practical, the

installation guidelines it contains. Careful installation will help ensure your 500 Series

speakers perform optimally and o er many years of listening enjoyment.

Every component in your 500 Series speaker is new and bespoke to this range. From the

high-power, low-distortion tonally-matched carbon bre tweeters and bass-drivers to the

RSC™ (Resonance Suppression Composite) cabinets. The aim being elimination of harmful

distortion so nothing distracts from your listening pleasure.

Why carbon bre?

At Acoustic Energy we don't believe in technology for the sake of it, we only use something

if it has a clear purpose and bene t. Traditionally we've used spun aluminium for our

transducers because of its lightness and sti ness when working as a piston, giving a highly

accurate reproduction of the source waveform. The bene t of carbon bre is that it has

similar pistonic properties to aluminium but in addition is both lighter, helping e ciency &

transient response, and has improved self-damping; minimising cone/dome break-up

harshness.

Should you have any questions not covered here or need more in-depth set-up advice we are

happy to try and answer your queries either by telephone or email.

Contact information can be found on the back of this manual.

Connections

WARNING: Check that your ampli er is switched o before installing your loudspeakers.

Failure to do so may result in speaker or ampli er damage.

The positive cable from the ampli er positive (or red) terminal should connect with the

positive (red) terminal on the loudspeaker. Similarly the negative cable should connect the

ampli er negative terminal (black) to the negative terminal (black) on the loudspeaker.

After wiring up, lower the volume to the minimum, switch on the ampli er, select the signal

source and then raise the volume to the listening level required whilst music is playing. If any

distortion is heard turn the ampli er down until the distortion disappears. If distortion

continues turn o the system and check connections again to make sure there are no

problems such as bare wires touching each other.

Speaker

(Rear)

CMY

If in any doubt with regards to connections or safety with your Hi-Fi system please contact

the dealer from which you purchased your system for advice. You can also contact Acoustic

Energy directly via email at: [email protected] or by phone on: (+44) 1285 654432.

(diagram for illustration purposes only)

Speaker

(Rear)

Ampli er (Rear)

- +