CAMDEN CM-110SK Manual de instrucciones de instalación - Página 4

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Teclado CAMDEN CM-110SK. CAMDEN CM-110SK 6 páginas. Standalone keypad

Imprimir página

8. Reset to Factory Default

a. Disconnect power from the unit

b. Press and hold # key while powering the unit back up

c. On hearing two "Beeps" release # key, system is now

back to factory settings

9. Anti-Tamper Alarm

The unit uses a LDR (light dependent resistor) as an

anti-tamper alarm. If the keypad is removed from the cover,

the tamper alarm will operate.

10. Sound and Light indication

Operation Status

Power on

Standby

Press keypad

Operation successful

Operation failed

Enter into programming mode

In the programming mode

Exit from the programming mode

Open the door

Alarm

11. Detailed Programming Guide

11.1 User Settings

To enter the programming mode

To exit from the programming mode

Note that to undertake the following programming, the master user must be logged in

To change the master code

To add a Pin user

Standalone Keypad Installation Instructions

Note: Only the installer data is restored, user

data will not be affected.

Red Light

Green Light

Bright

Master code #

999999 is the default factory master code

New code

The master code can be 6 to 8 digits long

User ID number

The ID number is any number between 1 & 2000.

The PIN is any four digits between 0000 & 9999 with

the exception of 1234 which is reserved. Users can be

added continuously without exiting programming mode

as follows:

1 User ID no 1

Page 4 of 6

Yellow Light

Bright

New code #

# PIN # User ID no 2 # PIN #

Buzzer

Beep

Beep/Beep/Beep

Beep

Alarm