Alto DYNAMATE Manual del usuario - Página 14

Navegue en línea o descargue pdf Manual del usuario para Equipos de grabación Alto DYNAMATE. Alto DYNAMATE 19 páginas.

Installation Instructions

Isolate individual circuits to maintain power to the remainder of the vehicle's electrical system.

At the far right of the side panel is a POWER INPUT terminal block with three screw terminals. The terminal marked

should be connected to a permanent 12 Volt supply from the vehicle battery.

The terminal marked GND (Ground) should be connected to a cable which is terminated to the vehicle chassis. Ensure

that the point where this cable attaches to the vehicle chassis provides good electrical contact. If drilling a new ground

point, ensure that it is safe (check that there is nothing behind the panel you are about to drill, such as the fuel tank). It

may be necessary to rub away paintwork to expose the metal at this point - in this case, after making a firm screw connection

of the ground cable to the chassis, paint over the terminal point to protect it from the possibility of corrosion.

Where a ground point already exists (for an existing power amplifier, for example) it is generally best practice to ground

the DYNAMATE to this same point on the vehicle chassis.

The terminal marked REM accepts a 12V switched input from the source unit (Cassette or CD player). When the source

unit is switched on, a 12V pulse is sent down this line. The DYNAMATE senses this pulse and switches itself on or off.

The source unit should be equipped with a suitable Remote Switch cable - check the instruction book supplied with your

audio source unit.

If the Remote output from the source unit is already being used to switch on a power amplifier, it is usually possible to

create a 'daisy-chain' by connecting a cable from the REM or Remote terminal on the amplifier to the REM terminal of

the DYNAMATE. This avoids the need to run a separate cable from the source unit.

Before reconnecting power to the circuit, double check all connections (be particularly careful to check there are no strands

of wire that could touch the chassis of the DYNAMATE or one of the other terminals).

The power-on LED next to the power input terminal block will light to show the unit is receiving power.

LTO

12V