3DR LiveView Kit for GoPro Manual del usuario

Navegue en línea o descargue pdf Manual del usuario para Drones 3DR LiveView Kit for GoPro. 3DR LiveView Kit for GoPro 2 páginas.

LiveView

™

User Guide

Transmitter Assembly

Attach a dual lock strip to the flat side of the video transmitter to prepare

it to mount to the copter. Connect the air antenna (red) to the transmitter.

The transmitter has two ports: a two-wire port and a three-wire port.

Connect the black connector on the splitter cable to the transmitter's

two-wire port. The transmitter's three-wire port will connect to the GoPro

video cable. On the end of the GoPro video cable with two connectors,

select the connector with the more widely-set wires. Orient the connector

with the metal pins facing in the same direction as the velcro, and

connect to the transmitter's three-wire port.

For X8+, do not connect the GoPro video cable; the transmitter will

connect to the pre-installed video output cable on the vehicle.

GoPro video cable

Antenna

Splitter cable

GoPro video cable

Kit for GoPro

Select the connector

with the larger space

between the two wires.

Complete transmitter wiring

Parts

Monitor

Splitter cable

Mounting bracket

Air antenna

Ground antennas (2)

Video transmitter

GoPro video cable

Mounting velcro

GoPro HERO Assembly

For X8+, use the GoPro video cable pre-installed onto the vehicle.

For other vehicles, use the GoPro video cable provided with this kit.

Connect the micro-USB end of the cable to the GoPro's micro-USB port.

GoPro video cable to GoPro HERO wiring

Insert the mounting screw provided with the cable through the cable

plate and attach to the hole in the gimbal marked below. This will secure

the cable to the gimbal.

Secure cable to gimbal

Important note: Make sure that the WiFi on your GoPro is

turned OFF at all times when in use with your copter. The WiFi

signal can interfere with the copter's radio communication and

cause unexpected behavior.