3DR Y6 Manual de montaje - Página 5

Navegue en línea o descargue pdf Manual de montaje para Drones 3DR Y6. 3DR Y6 13 páginas.
También para 3DR Y6: Manual de inicio rápido (8 páginas)

Your Y6 has three legs, each comprised of two C-type landing gear pieces. To assemble each

leg, align the two pieces and attach through four bottom holes using four 18 mm threaded

spacers and eight 5 mm nylon bolts.

25 mm bolts

Leg assembly

POW E R W I RING

The power distribution board (PDB) allocates power to

your copter's motors. Place the PDB in the center of

your copter through the hole in the top plate, resting on

top of the bottom plate. You may want to experiment

with the orientation of the board to accommodate all

necessary wiring.

Electronic speed controllers (ESCs) regulate how much power is applied to each motor. To

connect the six ESCs to the PDB, you will need to solder the provided Deans connectors to the

ESCs' black and red wires.

Add a half-inch length of heat shrink tubing onto

each ESC red wire and black wire. Solder the

positive Deans connector plug to the red wire

and the negative Deans connector plug to the

black wire. Shrink tubing over connections.

Metal nuts

18 mm

spacers

5 mm

nylon

bolts

Deans to ESC:

Negative = Black

Positive = Red

For each hole, position spacer between holes;

secure from each side with nylon bolts.

Repeat for all three legs.

Attach legs to arms with C-shape facing

toward motors (to provide clearance for

propellers on bottom motors). Align the two

top holes in the leg with the two holes in the

center of the arm. Insert two 25 mm bolts and

secure with metal nuts.

PDB between top and bottom plates

Add heat shrink and align wires to correct plugs.

Soldered connectors